IPSec tunnel between Juniper SRX and InRouter
If inscribe.
How to do hard reset?
For IR600 and IR900. Restore to factory default via front panel RESET button: Step 1. Locate the RESET button on the device; Step 2. Turn on the device’s power; within 10 seconds, press and hold RESET button; Step 3. When ERR LED is on, release the RESET
How to configure DDNS in IR302?
1. Open Web site http://www.noip.com create an account Put in Email Username Password Domain name. P-1 2. Confirm the email sent by NoIP and verify the account by clicking "Confirm Account". P-2 3. Log in NoIP P-3-1 P-3-2 4. ConfigIR302 4.1 Make sure
How can I access my IR302 when I enable IP Passthrough？
The LAN ip of IR302 will change after you configure IP Passthrough. It becomes the first 16 bit mask IP in the IP segment assigned by the operator to the downstream device of IR302. You can also check the gateway of the downstream device, and that IP
How to configure Link Backup between Wired and Wi-Fi for IR302?
1. Go to Network >> WAN.We select Static IP for the WAN connection, and configure the WAN portas follows: 2. Configure WLAN as STA mode. 1) Go to Network >> WAN(STA), selectDHCP for WLAN connection. 2) Go to Network >> WLAN(Client), and then click Scan.Now
What is the Dual-SIM switch mechanism of IR302?
Main SIM card is the SIM card that enables dialing first after the device is on. When Main SIM is disconnected for some reason or fail to dial up, and then Backup SIM will be on. The settings of Max Number of Dial, CSQ Threshold and Min connected time
How to configure WLAN STA mode in IR302?
1) Go to Network ->Switch WLAN Mode, select STA. 2) Reboot after apply the configuration. 3) Go to Network >> WAN(STA), selectDHCP for WLAN connection. 4) Go to Network->WLAN Client, apply the default configuration first. 5) Click Scan, and then connect
How to configure the IR302 as WLAN WDS?
1) Select AP mode. Go to Network-> Switch WLAN Mode. The default mode of WLAN is AP. After the switch of mode, it needs a reboot to take effect. 2) Go to NETWORK->WLAN. Enable WLAN functionality. You’ll see the Wi-FI LED is flashing. 3) Enable WDS. Configure
How to configure WLAN AP mode in IR302?
1) Select AP mode. Go to Network-> Switch WLAN Mode. The default mode of WLAN is AP. After the switch of mode, it needs a reboot to take effect. 2) Go to NETWORK->WLAN. Enable WLAN functionality. 3) Change (if you wish) the SSID and the password. 4) Verify
IR302 Link Backup
If you want to use your regular internet as your primary, and use cellular as backup when your primary is down, IR302 Link backup function could help you switch the uplink automatically. By default, WAN/LAN port on IR302 is a LAN port, we need to change
Connect the downstream devices of two different sites through InConnect
I would like to connect IR302 routers in a way where all downstream devices can see each other. How would I go about doing this through InConnect? 1.Create the InHand Routers on InConnect dashboard, and then add the downstream devices. You can refer to
What is the power required to get it to work, can we connect it to a dc solar panel and batteries?
What is the power required to get it to work, can we connect it to a dc solar panel and batteries?
How to do Hardware Restore?
I have a router. The model is IR902. I can not remember the password. How to restore it?