Connect the Ethernet Cable

Notice:

1. Please make sure that the ethernet cable is inserted into the device in a standardized way. If not, the crystal head may be damaged when installing the waterproof PG head.
   
2. When removing the ethernet cable, the waterproof PG head must be removed first, and then the crystal head connected to the device must be removed.
   
3. Please confirm the diameter of the Ethernet cable is between 4.8 mm to 6.5 mm. 
   
4. Please ensure the cable glands are properly assembled to prevent leaks.
   
5. Cut the Ethernet cable to the appropriate length according to the distance from the ODU to the power supply and pass it through the bracket. 
   
6. Use the ethernet cable after the crystal head is processed and pass through the waterproof PG head in the order shown in the figure below.
   
7. Schematic diagram of patch cable passing through the waterproof head
   
8. Insert the Ethernet cable into the network port of the device, and tighten the waterproof head in the order of B, C, D, and E to complete the installation.
   

Connect PoE Power Adapter